Flow Switches


InnovaSwitch™

Nov 03, 2013 19466
InnovaSwitch™
InnovaSwitch™ Switches on a flow/no flow condition in both gases and liquids. Flow Switch range of 0.01 to 5 sfps (.003 to 1.524 smps) in liquids and 0.1 to 500 sfps (.03 to 152.4 smps) gases...

SERIES DKM, DKM/A, DKG : VISCOSITY COMPENSATING INDICATORS AND SWITCHES

Oct 05, 2017 17
Full scale flow ranges from 60cc/m to 40 GPM and 4 SCFM to 400 SCFM Connection sizes from 1/4-inch to 1-inch NPT or BSP

SERIES HFS* : HIGH PRESSURE/TEMPERATURE INDICATORS, SWITCHES, AND TRANSMITTERS

Oct 05, 2017 33
Full scale flow ranges from 1 to 150 GPM and 10 SCFM to 1,300 SCFM Connection sizes from 1/4-inch to 8-inch NPT, BSP, SAE or flange Construction materials: Brass, Stainless Steel, or Aluminum

Flow Switch Heavy Duty Model Q-5

Feb 07, 2017 216
Flow Switch  Heavy Duty Model Q-5
Flow Switch Heavy Duty Model Q-5 Switches on a flow/no flow condition in both gases and liquids. Flow Switch range of 0.01 to 5 sfps (.003 to 1.524 smps) in liquids and 0.1 to 500 sfps (.03 to 152.4 smps) gases...

Thermal Differential Flow Switch

Feb 07, 2017 262
Thermal Differential Flow Switch
Thermal Differential Flow Switch Thermal Differential Switches use a thermal differential technique to measure liquid flow, level or interface by sensing changes in the thermal heat transfer characteristics of the media where it is located...

Flow Switches For High Velocity Flows

Feb 07, 2017 1209
Flow Switches For High Velocity Flows
Flow Switches For High Velocity Flows This design utilizes a hinge-pin which allows the paddle to move through a 90° travel, swinging up to a horizontal position. It is only effective for actuation at the lower end of the flow spectrum -higher flows will disengage the bias spring...

Flow switch Type VKX05

Feb 07, 2017 241
Flow switch Type VKX05
Flow switch Type VKX05 The flow switch comprises a paddle system to whose end a permanent magnet is attached. Above this magnet is a reed contact, located outside the flow of fluid. A second magnet creates the force necessary to reset the switch back to the no flow position...